A flowable for all your clinical situations Nanofilled Wave, Wave MV and Wave HV contain specially treated nano-fillers to maximize polishability, wear resistance and strength. Ease of extrusion is improved with the addition of these specially treated nano-fillers. Radiopacity Wave, Wave MV and Wave HV are all visible on x-rays. This allows easy identification of secondary caries at the interface Begin by thoroughly cleaning and isolating the tooth to be treated. Next, remove any excess water from the area, but try to keep the surface moist if possible. A dry surface is also acceptable. Apply a bonding agent such as Go! to saturate all internal surfaces and leave it in place for 20 seconds. If using a different bonding agent, follow the manufacturer's instructions for application. Use dry and oil-free air to blow firmly on the surface for 5 seconds, leaving it glossy. Light cure the surface for 10 seconds. Directly inject Wave in small increments, no more than 2mm at a time, for: 6.1 Class V restorations 6.2 Tunnel preparations 6.3 Pit and fissure sealants 6.4 Minimal Class I, Class II, Class III and Class IV restorations, or other indications as required. Cure Wave for 20 seconds in increments of 2mm. Finally, polish and finish the tooth to complete the procedure.